Change tray selection
The product is set to automatically pull media from trays that contain media. The product always pulls media from tray 1 if you insert media into tray 1. If there is no media in tray 1, the product attempts to pull media from tray 3, if installed, and then from tray 2.
You can specify which tray you want to use by changing the tray selection. Auto select, Tray 1, Tray 2, and Tray 3 are available settings. Auto select will pull media from the first available tray with the appropriate matching media loaded.
| NOTE:
|
Tray 3 is only available if a tray 3 is installed.
|
Change the tray selection for the current job
| 1.
|
| On the product control panel, press Tray Select.
|
|
| 2.
|
| Use the arrow buttons to select the input tray that you want to use.
|
|
| 3.
|
| Press Start Copy to save the selection and immediately start the copy job, or press OK to save the selection without starting the job.
|
|
Change the default tray selection
| 1.
|
| On the product control panel, press Setup.
|
|
| 2.
|
| Use the arrow buttons to select Copy setup, and then press OK.
|
|
| 3.
|
| Use the arrow buttons to select Def. Tray Select, and then press OK.
|
|
| 4.
|
| Use the arrow buttons to select a tray setting, and then press OK.
|
|
HP Laserjet M2727 Change tray selection