Change the copy-collation setting
You can set the product to automatically collate multiple copies into sets. For example, if you are making two copies of three pages and the automatic collation is on, the pages print in this order: 1,2,3,1,2,3. If automatic collation is off, the pages print in this order: 1,1,2,2,3,3.
To use the automatic collation, the original document size must fit into the memory. If it does not, the product makes only one copy and a message appears notifying you of the change. If that happens, use one of the following methods to finish the job:
| ●
|
| Split the job into smaller jobs that contain fewer pages.
|
|
| ●
|
| Make only one copy of the document at a time.
|
|
| ●
|
| Turn off the automatic collation.
|
|
Change the copy-collation setting for the current job
| 1.
|
| On the product control panel, press Collate.
|
|
| 2.
|
| Use the arrow buttons to select On or Off.
|
|
| 3.
|
| Press Start Copy to save the selection and immediately start the copy job, or press OK to save the selection without starting the job.
|
|
Change the default copy-collation setting
| 1.
|
| On the product control panel, press Setup.
|
|
| 2.
|
| Use the arrow buttons to select Copy setup, and then press OK.
|
|
| 3.
|
| Use the arrow buttons to select Def. Collation, and then press OK.
|
|
| 4.
|
| Use the arrow buttons to select On or Off.
|
|
| 5.
|
| Press OK to save the selection.
|
| NOTE:
|
The factory-set default for automatic copy collation is On.
The Collate LED on the control panel is on when collation is on.
|
|
HP Laserjet M2727 Change the copy-collation setting