Link speed setting

Link speed setting

HP Laserjet M2727 note Link speed setting NOTE:

Incorrect changes to the link speed setting might prevent the product from communicating with other network devices. For most situations, the product should be left in automatic mode. Changes can cause the product to power cycle. Changes should be made only while the product is idle.

1.
On the control panel, press Setup.
2.
Use the arrow buttons to select Network config, and then press OK.
3.
Use the arrow buttons to select Link speed, and then press OK.
4.
Use the arrow buttons to select one of the following settings.
●
Automatic
●
10T Full
●
10T Half
●
100TX Full
●
100TX Half
HP Laserjet M2727 note Link speed setting NOTE:

The setting must match with the network product to which you are connecting (a network hub, switch, gateway, router, or computer).

5.
Press OK. The product will power cycle.
HP Laserjet M2727 Link speed setting